BWPBW - LEXSOL 408M
- MSDS: BWPBW
- Manufacturer: SANTA BARBARA CHEMICAL
- Product Name: LEXSOL 408M
- National Stock Number: 9150-00N057153
Product Identification
Product ID:LEXSOL 408M
MSDS Date:06/08/1993
FSC:9150
NIIN:00N057153
MSDS Number: BWPBW
Responsible Party
US
Emergency Phone: 800-424-9300(CHEMTREC)
Info Phone: 805-965-7513
Cage: 9Z769
Contractor
Telephone: 805-965-7513
Cage: 9Z769
Ingredients
XYLENE; (XYLENE + C*8 + AROMATICS) (SARA 313) (CERCLA)
CAS: 1330-20-7
RTECS: ZE2100000
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
NAPTHENES
OSHA PEL N/K
ACGIH TLV: N/K
PARAFFINS
OSHA PEL N/K
ACGIH TLV: N/K
ACETIC ACID, BUTYL ESTER; (BUTYL ACETATE) (CERCLA)
CAS: 123-86-4
RTECS: AF7350000
OSHA PEL 150 PPM
ACGIH TLV: 150 PPM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
782 G/L
RTECS: 9999999VO
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INHAL:MAY IRRITATE NOSE &
THROAT. PRLNGD EXPOS MAY CAUSE CHEST PAINS, HDCH, DIZZ & NAUS.
SKIN:MILDLY IRRIT, MAY PRDCE BURNING SENSATION. PRLNGD/RPTD CONT
MAY CAUSE SKIN TO BECOME RED, ROUGH & DR Y DUE TO REMOVAL OF
NATURAL OILS & MAY CAUSE DERM. THIS SOLV IS NOT READILY ABSORBED
THRU SKIN. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZS:EYES:MILD TO MOD IRRITANT, CAUSING
PAIN, LACRIMATION & GEN INFLAM. ESSNTLY NO CORNEAL INJURY.
INGEST:IRRIT TO MOUTH & THROAT, GI TRACT IRRIT, NAUS, VOMIT, POSS
CHEM PNEUM IF LIQ IS ASPIR INT O LUNGS. CHRONIC:POSS CNS DMG & SKIN
DERM. LACK OF APPETITE, ANOREXIA. OTHER EFTS OF LIVER & KIDNEY, &
PULM EDEMA.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:INHAL:REMOVE TO FRESH AIR. GIVE ARTIFICIAL RESPIRATION IF NOT
BREATHING. GET IMMEDIATE MED ATTN. SKIN:WASH WITH SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING AND FOOTWEAR. WASH CLOTHING BEFORE
REUSE. G ET MED ATTN IF IRRIT PERSISTS AFTER WASHING. EYES:FLUSH
IMMEDIATELY WITH COLD WATER FOR AT LEAST 15 MINUTES. SEEK MEDICAL
ATTENTION IF IRRIT PERSISTS. INGEST:GET MED ATTN IMMED. DO NOT
INDUCE VOMIT.
Fire Fighting
Flash Point Method:TCC
Flash Point:105F,41C
Lower Limits:1.0%
Upper Limits:6.0%
Extinguishing Media:USE FOAM, CO*2, OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . A STRAIGHT WATER STREAM WOULD SPREAD
HYDROCARBON FIRES.
Unusual Fire/Explosion Hazard:A VAPOR ACCUMULATION WOULD FLASH AND/OR
EXPLODE IF IGNITED. INCOMPLETE COMBUSTION WILL PRODUCE CARBON
MONOXIDE AND OTHER TOXIC SUBSTANCES.
Accidental Release
Spill Release Procedures:SPILLS SHOULD BE CNTND IMMED. LG SPILLS SHOULD
BE REMOVED BY VACUUM TRUCK. SMALLER SPILLS MAY BE SOAKED UP
W/ABSORB MATLS, PLACED IN CLSD CNTNRS, LBLD, STORED, & DISPOSED OF
PROPERLY. PERSON PERFORMIN G THIS WORK SHOULD WEAR ADEQ PERSONAL
PROT(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:NONE SPECIFIED BY MANUFACTURER.
Other Precautions:AVOID PROLONGED OR REPEATED SKIN CONTACT AND EYE
CONTACT WITH THIS MATERIAL.
Exposure Controls
Respiratory Protection:THE USE OF RESPIRATORY PROTECTION DEPENDS ON
VAPOR CONCENTRATIONS ABOVE THE TIME-WEIGHED TLV:USE A NIOSH/MSHA
APPROVED CARTRIDGE RESPIRATOR OR GAS MASK.
Ventilation:USE ADEQUATE VENTILATION TO KEEP THE VAPOR OR MIST OF THIS
MATERIAL BELOW APPLICABLE STANDARDS.
Protective Gloves:USE SOLVENT RESISTANT GLOVES.
Eye Protection:CHEM GOGGLES & PLASTIC FSHLD (SUPP DATA)
Other Protective Equipment:WEAR PROTECTIVE CLOTHING COMPATIBLE WITH
ALIPHATIC HYDROCARBONS. EYE WASHES AND SAFETY SHOWERS ARE RECOM IN
WORK AREA.
Work Hygienic Practices:CONTAMINATED CLOTHING SHOULD BE REMOVED AND
WASHED IN HOT WATER WITH SOAP.
Supplemental Safety and Health
SPILL PROC:EQUIPMENT AND CLOTHING. EYE PROT:SHOULD BE WORN IF THERE IS
A DANGER OF SPLASHING. SAFETY EYE WEAR USED MUST BE ANSI APPROVED .
Chemical Properties
Boiling Pt:B.P. Text:320F,160C
Vapor Pres:2.19
Vapor Density:1.2
Spec Gravity:0.782 (H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR, COLORLESS LIQUID WITH A MILD ALIPHATIC
HYDROCARBON ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:OPEN FLAMES, HOT SURFACES, OR ANY IGNITION
SOURCE.
Hazardous Decomposition Products:NORMAL COMBUSTION FORMS CARBON DIOXIDE
AND WATER VAPOR; INCOMPLETE COMBUSTION CAN PRODUCE CARBON MONOXIDE.
Disposal
Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS .
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.